Chapter 1. IBM Flex System FC3171 8 Gb SAN Switch - QLogic
Chapter 1. IBM Flex System FC3171 8 Gb SAN Switch - QLogic
Chapter 1. IBM Flex System FC3171 8 Gb SAN Switch - QLogic
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Configuring the zoning database<br />
Use the Zoning Config dialog, shown in Figure 12, to change the Merge Auto Save,<br />
Default Zone, and Discard Inactive configuration parameters. Open the Zoning<br />
menu and select Edit Zoning Config to open the Zoning Config dialog. After<br />
making changes, click the OK button to put the new values into effect.<br />
Figure 12. Zoning Config dialog<br />
Merge auto save The Merge Auto Save parameter determines whether changes to<br />
the active zone set that a switch receives from other switches in the fabric will be<br />
saved to the zoning database on that switch. Changes are saved when an updated<br />
zone set is activated. Zoning changes are always saved to temporary memory.<br />
However, if Merge Auto Save is enabled, the switch firmware saves changes to the<br />
active zone set in temporary memory and to the zoning database. If Merge Auto<br />
Save is disabled, changes to the active zone set are stored only in temporary<br />
memory, which is cleared when the switch is reset.<br />
Notes:<br />
Disabling the Merge Auto Save parameter can be useful to prevent the propagation<br />
of zoning information when experimenting with different zoning schemes.<br />
However, leaving the Merge Auto Save parameter disabled can disrupt device<br />
configurations should a switch have to be reset. For this reason, the Merge Auto<br />
Save parameter should be enabled in a production environment.<br />
Default zone The Default Zone parameter enables (True) or disables (False)<br />
communication among ports/devices that are not defined in the active zone set or<br />
when there is no active zone set. This parameter must have the same value<br />
throughout the fabric.<br />
Discard inactive The Discard Inactive parameter automatically removes inactive<br />
zones and zone sets when a zone set is activated or deactivated from a remote<br />
switch.<br />
<strong>Chapter</strong> 3. Managing fabrics 31