AS-700, AS-710
AS-700, AS-710
AS-700, AS-710
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Error Messages Cause Remedy<br />
POSITION ERROR<br />
CHECK TOP MARGIN<br />
ADRESS TOO LONG<br />
CHECK TOP MARGIN<br />
HEAD INTERRUPT ERR<br />
OPEN SAFETY COVER<br />
SAFETY COVER OPEN<br />
DC MOTOR CONTROLLER<br />
FAULT<br />
CALL SERVICE<br />
ERROR PEN BOARD<br />
CALL SERVICE<br />
The print lies outside the<br />
paper format area.<br />
Text does not fit in the<br />
print object.<br />
Carriage remains stuck on<br />
a projecting print object .<br />
The safety cover is open<br />
and the carriage is in mid<br />
position.<br />
Motor controller fault.<br />
Error on the HP PEN<br />
board.<br />
Reduce the TOP MARGIN<br />
setting, either in the programming<br />
mode or with<br />
the ““ key. Or correct<br />
the PAPER SIZE.<br />
Reduce the TOP MARGIN<br />
setting, either in the programming<br />
mode or with<br />
the ““ key. Or correct<br />
the PAPER SIZE<br />
Open the safety cover and<br />
check if the carriage is<br />
able to move freely.<br />
Where applicable, remove<br />
jammed print object.<br />
When you have opened<br />
the safety cover because<br />
of an error message, then<br />
remedy the error (e.g.<br />
remove jammed sheet).<br />
When you close the safety<br />
cover, the printer is ready<br />
again.<br />
Replace boards.<br />
Check plug connection<br />
Replace PEN board.<br />
RAM ERROR<br />
CALL SERVICE<br />
PRINTER ERROR<br />
WRONG BOARD/FIRMWARE<br />
CPU-HW-ERROR #<br />
RESET THE PRINTER!<br />
ERROR CARTRIDGE<br />
CHECK CONNECTION<br />
FONT ERROR<br />
LOAD FL<strong>AS</strong>H FONTS!<br />
PAP. LEN TOO SMALL<br />
MIN. VALUE:<br />
ERROR PAPER SENSOR<br />
CHECK THE SENSOR<br />
Font Loading<br />
ERROR: TIMEOUT<br />
Font Loading<br />
ERROR:HEADER (SB)<br />
CPU board with small RAM<br />
memory.<br />
Severe CPU error.<br />
Cartridge error or TSR is<br />
wrong.<br />
Error in flash PROM.<br />
Paper too short.<br />
Paper light barrier.<br />
Error in download font<br />
Error in download font.<br />
Replace CPU .<br />
Use correct board and<br />
firmware<br />
Reload firmware; check<br />
the checksums!<br />
Check plug connection<br />
Replace cartridge.<br />
Reload fonts.<br />
Observe minimum length.<br />
Check download font.<br />
Check download font.<br />
65
Change language