AS-700, AS-710
AS-700, AS-710
AS-700, AS-710
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Note<br />
The print object must lie on top of the paper recognition.<br />
2. For the setting of the side guides, use the paper sensor as a benchmark. The<br />
paper side edge should extend at least 5 mm over the paper sensor.<br />
Illustration 5-30: Setting the directional control<br />
If the installed side guide (2) is not sufficiently wide, then replace it with one of the<br />
two wider guides included in the delivery (see Illustration 4-1: PRINTER <strong>700</strong>/<strong>710</strong><br />
overview).<br />
1. Loosen the locating screw (4) and lift the side guide (2) out of the opening.<br />
2. After the side guide has been set in position, move it to the desired width and<br />
fix it in position with the screw (4).<br />
5.4.2.4.2 Adjust Outfeed Rollers<br />
See HIllustration 4-4: PRINTER <strong>700</strong>/<strong>710</strong> safety cover<br />
The outfeed rollers can be pushed sideways using the handles.<br />
Arrange the outfeed rollers in such a way, that the print object is caught by the<br />
rollers, but that the print area is not in contact with the rollers (otherwise, smearing<br />
of the ink can occur).<br />
Assure yourself of the print object setting by carrying out a paper run without<br />
printing.<br />
5.4.2.5 Setting the Paper Support Plate<br />
Horizontal alignment<br />
1. With a wide, unstable print object surface, use the second guide bracket (5).<br />
2. Loosen the locating screw (7) and set both guide brackets (5) approximately<br />
in the middle.<br />
39