VL2500 Spot User Manual - Production Services Ireland

More documents

Recommendations

Info

VARI❋LITE® - <strong>VL2500</strong> SPOT LUMINAIRE USER’S MANUAL Rotating Gobo Replacement WARNING: Remove power from luminaire before performing maintenance. WARNING: <strong>User</strong>s of VARI❋LITE luminaires should not install or use metal gobos. The use of metal gobos in any VARI❋LITE product may damage the luminaire and could void the luminaire’s warranty. Tools: Screwdriver, Phillips #2 Hook and Pick tool (or small slotted screwdriver) Cotton gloves To remove and replace a rotating gobo: Step 1. Remove power from luminaire. Step 2. At removable cover, using #2 Phillips screwdriver, turn two captive screws and remove cover. (It will remain attached by tether.) Removable Cover Captive Screws Figure A-8: Replacing a Rotating Gobo Rotating Gobo Wheel CAUTION: Do not touch gobos with bare fingers. Wear cotton gloves or other covering while replacing. Clean with glass cleaner and soft cloth if required. 72 05-January-2004 02.9676.0019 A
TROUBLESHOOTING AND MAINTENANCE A Step 3. At rotating gobo wheel, rotate until required gobo/filter is accessible. Step 4. FOR GAGS OR GOBOS THAT DO NOT REQUIRE A CARRIER - Locate end of coiled spring which is fitted under carrier tab. Using hook and pick tool or small slotted screwdriver, push end of spring from under tab until it is free. Once free, remove entire coiled spring. Step 5. FOR GOBOS THAT ARE FITTED INTO THEIR OWN CARRIER - Remove gobo by pressing on side opposite of "O" Ring. Only For Gags or Gobos that do not require a carrier Spring Gobo Carrier Flat side Orient flat side to flat side of carrier Flat Locator Markers Free end of spring and then remove Figure A-9: Rotating Gobo Removal CAUTION: Do not touch gobos with bare fingers. Wear cotton gloves or other covering while replacing. Clean with glass cleaner and soft cloth if required. Step 6. Remove gobo. Step 7. Aligning flat side correctly and orienting “black” side of gobo toward front lens, install new gobo. Step 8. Re-install spring, ensuring it is fully secured under carrier tabs (for Gags or Gobos that do not require a carrier). Step 9. Re-install removable cover. 02.9676.0019 A 05-January-2004 73 Tab Spring
Page 2 and 3:
VARI❋LITE ® is a trademark owned
Page 4 and 5:
VARI❋LITE® - VL2500 SPOT LUMINAI
Page 6 and 7:
Page 8 and 9:
Page 10 and 11:
Page 12 and 13:
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Page 38 and 39: VARI❋LITE® - VL2500 SPOT LUMINAI
Page 94: (This page intentionally blank.)
show all

VL2500 Spot User Manual - Production Services Ireland

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?