VL2500 Spot User Manual - Production Services Ireland
VL2500 Spot User Manual - Production Services Ireland
VL2500 Spot User Manual - Production Services Ireland
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
TROUBLESHOOTING AND MAINTENANCE A<br />
CAUTION: Do not touch gobos with bare fingers. Wear cotton gloves or other covering while<br />
replacing. Clean with glass cleaner and soft cloth if required.<br />
Note: In some cases it is easier to slide bulkhead partially out of head assembly to access gobos. To do<br />
this, use #2 Phillips screwdriver to turn captive screw one-quarter turn and slide bulkhead upward.<br />
Disconnect motor connections as necessary.<br />
Step 3. Remove CYM Color / Dimmer Assembly.<br />
Step 4. Rotate wheel until required gobo is accessible at finger access cutout.<br />
Figure A-6: Gobo Access<br />
Step 5. Using fingers, pull gobo out of wheel.<br />
Step 6. Noting proper orientation of carrier indention<br />
and orienting “black” side of gobo toward front<br />
lens, insert new gobo into position and push fully<br />
into place.<br />
Step 7. Re-install bulkhead (if applicable) and re-install<br />
removable cover.<br />
Finger Access<br />
Cutout<br />
Figure A-7: Fixed Gobo Removal<br />
02.9676.0019 A 05-January-2004 71<br />
Gobo<br />
Gobo<br />
Carrier Indention<br />
Gobo Wheel
Change language