VL2500 Spot User Manual - Production Services Ireland

More documents

Recommendations

Info

VARI❋LITE® - <strong>VL2500</strong> SPOT LUMINAIRE USER’S MANUAL Routine Maintenance Lamp Replacement WARNING: Remove power from luminaire before performing maintenance. Tools: Screwdriver, slotted Cotton gloves To replace lamp: Step 1. Remove power from luminaire. WARNING: Lamps will be extremely HOT after operation. Allow lamp to cool before replacing. Step 2. At backcap, using slotted screwdriver (or fingers) turn captive knob until loose. Step 3. Slide backcap away from head assembly (it will remain attached by tether and lamp wires). Head Assembly Backcap Assembly Lamp Guide Rod Figure A-1: Replacing Lamp Captive Knob 66 05-January-2004 02.9676.0019 A
TROUBLESHOOTING AND MAINTENANCE A CAUTION: Wear cotton gloves or other covering while servicing lamp. Touching lamp glass with bare fingers will leave oil and may cause the lamp to explode or reduce lamp life. If required, use alcohol and cotton cloth to thoroughly clean glass portion of lamp. Step 4. Remove lamp by pulling straight out of socket. Step 5. Install new lamp by pressing into socket. Ensure lamp is fully seated in socket and parallel to guide rods. (Lamp can be damaged when inserted through reflector if not parallel to guide rods.) Step 6. Align guide rods in guide holes and slide backcap into head assembly. Re-tighten captive knob. Step 7. If required, reset lamp hour counter as follows. (Refer to “Menu System” chapter on page 49 for more information.) a. Power up luminaire. b. At Menu Display, press [Menu]. c. Press [Up] / [Down] arrows until Config (Configuration) appears. Press [Enter]. d. Press [Up] / [Down] arrows until LAMP appears. Press [Enter]. e. Press [Up] / [Down] arrows to access ResetHrs (Reset Lamp Hours). Press [Enter] to reset lamp hour counter. Step 8. Align lamp. Refer to “Align Lamp for Flat Field” on page 19. 02.9676.0019 A 05-January-2004 67
Page 2 and 3:
VARI❋LITE ® is a trademark owned
Page 4 and 5:
VARI❋LITE® - VL2500 SPOT LUMINAI
Page 6 and 7:
Page 8 and 9:
Page 10 and 11:
Page 12 and 13:
Page 14 and 15:
Page 16 and 17:
Page 18 and 19:
Page 20 and 21:
Page 22 and 23:
Page 24 and 25:
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33: VARI❋LITE® - VL2500 SPOT LUMINAI
Page 94: (This page intentionally blank.)
show all

VL2500 Spot User Manual - Production Services Ireland

Create successful ePaper yourself

Delete template?

Save as template?