Crocus SHDSL G703.pdf - FTP Directory Listing

Crocus SHDSL G703 Chapter 5 53
User manual
Step-by-step configuration
5 Step-by-step configuration
This chapter describes in a step-by-step manner how to perform a basic configuration on Crocus SHDSL
G703.
You are advised to read this chapter in a sequential manner, from the beginning to the end, without skipping
any part. By doing so, your Crocus SHDSL G703 will be completely configured and ready for use
when you reach the end of this chapter.
The following gives an overview of this chapter.
• 5.1 - Configuring the basic line parameters on page 54
• 5.2 - Configuring EOC handling on page 57
• 5.3 - Configuring the timing mode on page 64
• 5.4 - Clocking of Crocus devices to access PDH and SDH networks on page 65
• 5.5 - Configuring the clocking mode on page 82
• 5.6 - Configuring the minimum line speed on page 87
• 5.7 - Configuring framing and time slots on page 93
• 5.8 - Low speed limitations on the G703 interfaces on page 97
• 5.9 - Configuring the interface specific attributes on page 98
• 5.10 - Configuring the management attributes on page 99
• 5.11 - Configuring passwords on page 111
• 5.12 - Executing configuration actions on page 113
• 5.13 - Troubleshooting the Crocus SHDSL G703 on page 118
• 5.14 - Crocus SHDSL G703 compatibility with other SHDSL devices on page 119
For a complete overview of the attributes of the Crocus SHDSL G703, refer to the reference manual.