Crocus SHDSL G703.pdf - FTP Directory Listing

Crocus SHDSL G703 Chapter 6 139
Reference manual
Configuration attributes
crocusShdslTtRpG703/line/eocChannel
Default:itu-G.991.2
Range: proprietary / itu-
Use the eocChannel attribute to determine how the checksum of Embedded
G.991.2
Operations Channel (EOC) messages is calculated. Make sure that on both
the central and the remote device the eocChannel attribute is set to the same value.
The eocChannel attribute has the following values:
Value
proprietary
itu-G.991.2
Description
The checksum is calculated using a proprietary method.
The checksum is calculated using the G.SHDSL standard method.
crocusShdslTtRpG703/line/txEocMessages
Default:bothPairs
Range: pair1 / bothPairs
This attribute is only present on a Crocus SHDSL G703 2P (2 pair) version.
Use the txEocMessages attribute to send EOC messages on both line pair 1 and 2 (bothPairs) or on line pair
1 only (pair1).
crocusShdslTtRpG703/line/eocHandling
Default:none
Range: enumerated, see below
SHDSL devices can communicate with each other through the Embedded
Operations Channel (EOC). Use the eocHandling attribute to define the handling of the EOC messages.
For more information on EOC handling, refer to 5.2 - Configuring EOC handling on page 57.
crocusShdslTtRpG703/line/numExpectedRepeaters
Default:0
Range: 0 … 8
Use the numExpectedRepeaters attribute to set the number of Crocus SHDSL
G703 Repeaters that the Crocus SHDSL G703 can expect to find on the SHDSL line. If the actual
number of repeaters does not match the number you entered in the numExpectedRepeaters attribute, then
the invalidNumRepeaters alarm is raised.