Crocus SHDSL G703.pdf - FTP Directory Listing

Crocus SHDSL G703 Chapter 5 117
User manual
Step-by-step configuration
5.12.5 Loading the default configuration using a DIP switch
The following procedure shows how to load the default configuration using the Load Default Configuration
DIP switch on the Crocus SHDSL G703 PCB:
Step
Action
1 Disconnect the Crocus SHDSL G703 from the power supply.
2 Set DIP switch bank DS1 position 2 to off.
To locate this DIP switch bank and for the DIP switch setting procedure, refer to 3 - DIP
switches and straps of the Crocus SHDSL G703 on page 33
3 Reconnect the power supply to the Crocus SHDSL G703.
⇒The Crocus SHDSL G703 reboots and loads the default configuration.
4 Activate the loaded default configuration:
1. Open a management session (e.g. TMA, ATWIN, …) on the Crocus SHDSL G703.
Refer to 4.1 - Starting TMA on the Crocus SHDSL G703 on page 42.
2. Execute the Activate Configuration action.
5 Again, disconnect the Crocus SHDSL G703 from the power supply.
6 Reset the appropriate DIP switch to on (see step 2).
7 Properly replace the cover as described in 3.1.4 - Changing DIP switch and strap settings
of the TT on page 39 and reconnect the power supply.
⇒The Crocus SHDSL G703 reboots in normal operation mode.