BRIDGE 4400 CAN

28
8 - PROGRAMMING 9 - Coupling of modules / siren 4310 / satellite alarm ICD 213X
on Cobra Bus line.
HOW TO START PROGRAMMING
A
D
OFF
OFF
ALARM
SYSTEM
DISARMING
ON
ON
IGN +15
HOW TO CHANGE TABLE
OFF
OFF
ON
ON
B
E
C
F
HOW TO GO OUT
1 FLASH
HOW TO CHANGE LINE HOW TO ACTIVATE/DEACTIVATE A FUNCTION
OK
On the Cobra Bus line (pin 10) it is possible to connect the following
additional modules (Siren 4310 / anti - lifting module / satellite alarm
ICD 213X / Engine lock 8509) by means of the following programming
procedure:
1. Disconnect system.
2. Enter programming mode using the dedicated procedure
for the product.
3. Move from page 2 to page 7 by activating and de - activating
the panel (+15 ON / OFF).
4. The storage and completion of programming is signalled
by flashing indicator lights.
NOTE: if two 8509 modules are to be connected, it is necessary
to memorize one module first then exit the programming mode,
and then repeat the operation for the second one by re-entering
the programming mode.
Repeat from point 1 if a module of the Cobra Bus line is disconnected.
NOTE: with the alarm disarmed, if a module self-learned by the
Cobra Bus line is disconnected, when the system is armed there
will be 8 to 12 signalling flashes of the direction lights; if it is
activated, there will be 8 to 12 Buzzer signals.
IMPORTANT: if the KIT includes a 4310 siren with backup battery,
it is not necessary to carry out the inclusion procedure as it
has already been included in the factory.
GB
USER AND FITTING INSTRUCTIONS 4400