NGC-40 Hardware Manager - Pentair Thermal Management
NGC-40 Hardware Manager - Pentair Thermal Management NGC-40 Hardware Manager - Pentair Thermal Management
The Ethernet port can be connected to any Ethernet upstream devices. COM1, COM 2 – RS-485 Wires are connected to COM 1 or COM2 via an RS-485/RS-232 converter, and from there to a computer. After all the desired changes have been made, press the APPLY button to save the changes or OK to save and exit. THERMAL MANAGEMENT SOLUTIONS EN-DigiTraceNGC40HWManager-IM-H58450 04/13 20/39
If you are done making changes, return the switch to RUN mode. All the communication parameter changes will be implemented. You can access the “Edit Settings” again to confirm the changes; all fields will now be black. THERMAL MANAGEMENT SOLUTIONS EN-DigiTraceNGC40HWManager-IM-H58450 04/13 21/39
- Page 1 and 2: USER MANUAL NGC-40 Hardware Manager
- Page 3 and 4: Section − 1 INTRODUCTION 1.1 Welc
- Page 5 and 6: When the file location and access o
- Page 7 and 8: During installation a program icon
- Page 9 and 10: The connection settings screen will
- Page 11 and 12: 3.2 Connecting via Ethernet If you
- Page 13 and 14: A window will appear. Enter the IP
- Page 15 and 16: 3.3 Configuration of the NGC-40-BRI
- Page 17 and 18: IMPORTANT: After making changes to
- Page 19: COM 1 and COM 2 are the RS-485 port
- Page 23 and 24: Section − 4 WORKING WITH CONNECTE
- Page 25 and 26: THERMAL MANAGEMENT SOLUTIONS EN-Dig
- Page 27 and 28: Information about the version of NG
- Page 29 and 30: Status - shows the current status.
- Page 31 and 32: Step 2 Cycle Power on the NGC-40-B
- Page 33 and 34: Once the NGC-40-BRIDGE has been boo
- Page 35 and 36: After you have selected the file it
- Page 37 and 38: The status bar displays the progres
- Page 39: WWW.THERMAL.PENTAIR.COM NORTH AMERI
The Ethernet port can be connected to any Ethernet upstream<br />
devices.<br />
COM1, COM 2 – RS-485<br />
Wires are connected to COM 1 or COM2 via an RS-485/RS-232<br />
converter, and from there to a computer.<br />
After all the desired changes have been made, press the APPLY<br />
button to save the changes or OK to save and exit.<br />
THERMAL MANAGEMENT SOLUTIONS EN-DigiTrace<strong>NGC</strong><strong>40</strong>HW<strong>Manager</strong>-IM-H58450 04/13 20/39