2012-2013 products & technique catalog - Danville Materials

Prelude TM Self-Etch Technique
1
2
3
Adhesives
4
For Anti-microbial protection MicroPrime
B or G may be applied and
dried. Apply Primer (#1) to enamel
& dentin. Scrub for 10 seconds with
a MicroBrush*. Do not rinse.
Use an air syringe to gently evaporate
the solvent. Surface need not
remain shiny.
Apply Adhesive (#2) with a
new MicroBrush*. Scrub for 10
seconds.
For direct restorations: as the first
5 6 increment, place 1/2 mm layer of
flowable composite over entire
floor and box form. Be sure to
seal junction of band and box with
flowable. Light cure.
Evaporate solvent with gentle air
stream. Increase air pressure to
thin Adhesive.
Prelude TM
1
Light cure 10 seconds @ 800
mwatts. Apply composite.
Total-Etch Technique
2
3
For indirect restorations:
Dab Dual/Self-Cure Link (#3)
liberally onto Adhesive with a
MicroBrush. Evaporate solvent
with air syringe. Apply self cure or
dual cure composite to restoration
(primed appropriately) and seat.
Warning: Dual/Self-Cure Link may
shorten the working time of some selfcure
and dual -cure composites.
Etch surface for 10 seconds with
SureEtch phosphoric acid etchant. Do
not scrub. Rinse well.
Do not blow dry. Blot excess water
with a new MicroBrush*, foam
pellet or large paper point. For antimicrobial
protection MicroPrime B
or G can be applied and left damp.
Apply Adhesive (#2) with a
new MicroBrush*. Scrub for 10
seconds.
4
5
6
For
direct restorations: as the first
increment, place 1/2 mm layer of
flowable composite over entire
floor and box form. Be sure to
seal junction of band and box with
flowable. Light cure.
Evaporate solvent with gentle air
stream. Increase air pressure to
thin Adhesive.
*Not a trademark of Danville Materials
Light cure 10 seconds @ 800
mwatts. Apply composite.
For indirect restorations:
Dab Dual/Self-Cure Link (#3)
liberally onto Adhesive with a
MicroBrush. Evaporate solvent
with air syringe. Apply self cure or
dual cure composite to restoration
(primed appropriately) and seat.
Warning: Dual/Self-Cure Link may
shorten the working time of some selfcure
and dual -cure composites.
Call 800/827-7940 or visit danvillematerials.com
21