COSHH REGULATIONS 1999 & EH 40/97 MATERIAL ... - Armstrong
COSHH REGULATIONS 1999 & EH 40/97 MATERIAL ... - Armstrong COSHH REGULATIONS 1999 & EH 40/97 MATERIAL ... - Armstrong
TRANSPORT CONSIDERATIONS: No specific requirements. REGULATORY INFORMATION: Specific labelling according to EEC Directives is not required. Other references: The Health and Safety at Work Act 1974 Control of Substances Hazardous to Health Regulations 1994 (COSHH) The Chemicals (Hazard Information and Packaging for Supply) Regulations 1994 (CHIP 2) Approved Code of Practice to Chip 2 EH40/97 – Occupational Exposure Limits 1997 The Chemicals (Hazard Information and Packaging for Supply) (Amendment) Regulations 1998 OTHER INFORMATION: The information contained herein is based on the present state of our knowledge and only describes the products in relation to their safety requirements. Recipients must take responsibility for following the recommendations given and for observing all applicable regulations and laws. If there are any queries please contact: Internal Technical Sales 0800 371849 Acoustic Fleece COSHH.doc Created Jun 2001 Page 6 of 10 WORLD INDUSTRIES LIMITED
MATERIAL SAFETY DATA SHEET (Approved Code of Practice to CHIP 2) PRODUCT: Premium Acoustic Infill Board SUPPLIER: Armstrong World Industries Ltd Building Products Division Armstrong House 38 Market Square Uxbridge Middlesex UB8 1NG Telephone: 01895 251122 COMPOSITION: Perlite, Starch, Clay, Mineral Wool, Paper Pulp, Binders, Stabilisers and with thin decorative coverings HAZARDS IDENTIFICATION: None if used in accordance with the supplier’s instructions. If creating excessive dust, which is at an occupational exposure level exceeding 5mg/m3 (or 2 fibres/ml) of inhalable dust when averaged over an 8-hour time period, respiratory protection should be worn. If excessive dust occurs: Ingestion: Skin: Eyes: Inhalation: May cause irritation and discomfort. Prolonged and repeated contact may cause irritation. May cause transient irritation. Dust may cause irritation in the respiratory tract. No hazard is known of the long-term effects of over-exposure under conditions of good industrial hygiene. FIRST AID MEASURES: Ingestion: Skin Contact: Eye Contact: Inhalation: Give plenty of liquids to drink - if symptoms develop, seek medical attention Thoroughly rinse and wash the affected area in clean water. If allergic reaction develops seek medical attention Irrigate thoroughly in clean water. If irritation persists seek medical attention. Remove away from contamination to fresh air. Page 7 of 10 WORLD INDUSTRIES LIMITED
- Page 1 and 2: COSHH REGULATIONS 1999 & EH 40/97 M
- Page 3 and 4: TOXICOLOGICAL INFORMATION: No known
- Page 5: HANDLING AND STORAGE: No special me
- Page 9 and 10: Oxidising Properties: Vapour Pressu
<strong>MATERIAL</strong> SAFETY DATA SHEET<br />
(Approved Code of Practice to CHIP 2)<br />
PRODUCT:<br />
Premium Acoustic Infill Board<br />
SUPPLIER:<br />
<strong>Armstrong</strong> World Industries Ltd<br />
Building Products Division<br />
<strong>Armstrong</strong> House<br />
38 Market Square<br />
Uxbridge<br />
Middlesex UB8 1NG<br />
Telephone: 01895 251122<br />
COMPOSITION:<br />
Perlite, Starch, Clay, Mineral Wool, Paper Pulp, Binders, Stabilisers and with thin decorative<br />
coverings<br />
HAZARDS IDENTIFICATION:<br />
None if used in accordance with the supplier’s instructions. If creating excessive dust, which<br />
is at an occupational exposure level exceeding 5mg/m3 (or 2 fibres/ml) of inhalable dust<br />
when averaged over an 8-hour time period, respiratory protection should be worn.<br />
If excessive dust occurs:<br />
Ingestion:<br />
Skin:<br />
Eyes:<br />
Inhalation:<br />
May cause irritation and discomfort.<br />
Prolonged and repeated contact may cause irritation.<br />
May cause transient irritation.<br />
Dust may cause irritation in the respiratory tract.<br />
No hazard is known of the long-term effects of over-exposure under conditions of good<br />
industrial hygiene.<br />
FIRST AID MEASURES:<br />
Ingestion:<br />
Skin Contact:<br />
Eye Contact:<br />
Inhalation:<br />
Give plenty of liquids to drink - if symptoms develop, seek medical<br />
attention<br />
Thoroughly rinse and wash the affected area in clean water. If allergic<br />
reaction develops seek medical attention<br />
Irrigate thoroughly in clean water. If irritation persists seek medical<br />
attention.<br />
Remove away from contamination to fresh air.<br />
Page 7 of 10<br />
WORLD INDUSTRIES LIMITED
Change language