and Multimode Inlet for Drinking Water Analysis - Agilent Technologies

More documents

Recommendations

Info

$Sophisticated peak-based fraction collection – working with up and ...$

PTV - Solvent Vent (elimination) Mode Syringe needle Baffled Liner • Set inlet temperature at or below solvent boiling point Carrier • Set high split ratio Vent • Inject sample very slowly into PTV • Solvent evaporates through split vent Sample Analyte Solvent Column • Close split vent and ramp PTV temperature • Carry out separation on analytical column
MMI Cold Splitless and SV – Temperature and Flow Programs Cold Injection Transfer of sample from inlet to column GC Separation 0.9 min MMI Temp 20 350 GC Oven Oven = 40 Temp MMI cooldown Oven ramps Purge Status purge off purge on Min 0 0.05 0.6 1.5 2.5 26
Page 1 and 2: New 7693 Autosampler and Multimode
Page 3 and 4: Two New Products from Agilent to En
Page 5 and 6: 7693A Injector & Tray Features •
Page 7 and 8: New 16 Sample Capacity in ALS Injec
Page 9 and 10: Lifetime and Reliability Testing
Page 11: Example Sample Prep Method for Prep
Page 17 and 18: New Multimode Inlet for Gas Chromat
Page 19 and 20: Agilent’s New Programmable Inlet
Page 21 and 22: MMI Programmable Temperature Vapori
Page 23 and 24: MMI Cold Splitless and SV - Tempera
Page 25 and 26: Compare cold to hot splitless S/N u
Page 27: Compare hot-to-cold splitless %RSDs
Page 31 and 32: Solvent Elimination Calculation Wiz
Page 33 and 34: Upload Parameters to your Method St
Page 35 and 36: Compare Hot SL, Cold SL and SV - %R
Page 37 and 38: New MMI-LVI Methods Development Whe

and Multimode Inlet for Drinking Water Analysis - Agilent Technologies

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?