Download manual - Systema Polska Sp. z o.o.

Airtight gas convectors
SYSTEMA S.p.A.
Draw 28
3.10 Electrical connections from the control panels to the devices
Check to make sure that a good ground connection has been made and respect the correct
connections of the phase and neutral wires. otherwise the flame detection and control systems
will not work.
3.11 Starting and operation of pilot flame devices (Mod. K21, K28,
K40, K55, K28V, K40V, K55V)
1) Set the dial (1) in the (î) position (¬) on the index (See Draw ).
2) Press the dial (1) and keep it pressed down for approx. 10 seconds.
3) Press the piezoelectric button (12) to light the burner’s pilot flame.
4) After lighting the burner’s pilot flame, keep the dial (1) pressed down for approx. 10 seconds,
and then release.
5) Turn the dial (1) counter-clockwise to fire the main burner and set it on the index at values
from 1 to 7 which correspond to 13 ° - 38 °C respectively.
6) In order to switch the main burner off, rotate the dial (1) to the (î) position (¬) on the index.
In order to switch the burner’s pilot flame off (and consequently the unit itself), turn the dial
(1) to the (l) position (l) on the index.
Wait 60 seconds before trying to start the device again.
33
Rev. 05IT0112-1