User Manual - Etilize
User Manual - Etilize
User Manual - Etilize
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
The system-event log contains POST and system management interrupt (SMI)<br />
events and all events that are generated by the baseboard management<br />
controller that is embedded in the integrated management module.<br />
Important: If the system-error LED on the front of the server is lit but there are<br />
no other error indications, clear the system-event log. Also, after you complete a<br />
repair or correct an error, clear the system-event log to turn off the system-error<br />
LED on the front of the server.<br />
– POST Event Viewer<br />
Select this choice to enter the POST event viewer to view the POST event<br />
log.<br />
– System Event Log<br />
Select this choice to view the system event-log.<br />
– Clear System Event Log<br />
Select this choice to clear the system event-log.<br />
v <strong>User</strong> Security<br />
Select this choice to set or clear passwords. See “Passwords” on page 72 for<br />
more information.<br />
This choice is on the full and limited Setup utility menu.<br />
– Power-on Password<br />
Select this choice to set a power-on password. See “Power-on password” on<br />
page 72 for more information.<br />
– Administrator Password<br />
Select this choice to set an administrator password. An administrator<br />
password is intended to be used by a system administrator; it limits access to<br />
the full Setup utility menu. If an administrator password is set, the full Setup<br />
utility menu is available only if you type the administrator password at the<br />
password prompt. For more information, see “Administrator password” on<br />
page 72.<br />
v Save Settings<br />
Select this choice to save the changes that you have made in the settings.<br />
v Restore Settings<br />
Select this choice to cancel the changes that you have made in the settings and<br />
restore the previous settings.<br />
v Load Default Settings<br />
Select this choice to cancel the changes that you have made in the settings and<br />
restore the factory settings.<br />
v Exit Setup<br />
Select this choice to exit from the Setup utility. If you have not saved the<br />
changes that you have made in the settings, you are asked whether you want to<br />
save the changes or exit without saving them.<br />
Chapter 3. Configuring the server 71
Change language