User Manual - Etilize

Installing the virtual media key
To install the virtual media key, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 29.
2. Unlock and remove the side cover (see “Removing the side cover” on page 32).
3. Align the virtual media key with the mounting tab and slide it down the tab onto
the connector on the system board. Press the virtual media key down into the
connector until it is firmly seated on the system board.
Virtual media
key (front)
Virtual media
key connector
Mounting bracket
(rear)
Mounting tab
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 62.
Installing a hot-swap power supply
The following notes describe the type of power supply that the server supports and
other information that you must consider when you install a power supply:
v The type and number of power supplies vary by server model. The server comes
with at least one power supply.
v Some servers come with a hot-swap power supply that supports redundant
mode. The redundant mode requires two operational hot-swap power supplies in
the server.
58 System x3200 M3 Types 7327 and 7328: Installation and User’s Guide