User Manual - Etilize

PCI slot 1
PCI slot 2
ServeRAID-MR10is
controller
Note: The drive cage should be in the open position. This illustration shows it
in the closed position.
8. Press the ServeRAID-MR10is SAS/SATA controller firmly into the connector on
the system board.
9. Take the other end of the signal cable that is attached to the drive backplane
section for drive bays 0 through 3 (as labeled on the front of the drive cage)
and connect it to the connector that is closest to the battery on the
ServeRAID-MR10is SAS/SATA controller.
10. Replace the hard disk drive fan assembly:
a. Insert the hard disk drive fan assembly retaining tab over the right edge of
the hard disk drive backplane; then, rotate the hard disk drive fan assembly
toward the backplane. Do not fully close the hard disk drive fan assembly.
b. Route the signal cables and power cable through the slot on the edge of
the hard disk drive fan assembly. Make sure that the cables will not be
pinched between the hard disk drive fan assembly and the hard disk drive
backplane when the assembly is installed.
c. Rotate the hard disk drive fan assembly toward the backplane until the
release tabs are fully engaged and snap into place.
11. Reconnect the hard disk drive fan assembly cable to the system board.
12. Rotate the drive cage back into the server until it stops; then, press and hold
the retaining tab on top of the drive cage while you rotate the drive cage into
the chassis until it is in the closed position.
13. Reinstall the hard disk drives.
Note: Before you continue, check all internal power cables to make sure that
they are connected to the system board and other optional devices.
14. Replace the side cover (see “Reinstalling the side cover” on page 64). Go to
“Completing the installation” on page 62.
15. Lock the side cover.
16. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Chapter 2. Installing optional devices 57