User Manual - Etilize
User Manual - Etilize
User Manual - Etilize
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
8. If you are installing a full-length adapter, remove the blue adapter guide (if any)<br />
from the end of the adapter.<br />
Adapter guide<br />
9. Carefully grasp the adapter by the top edge or upper corners, and align it with<br />
the expansion slot guides; then, press the adapter firmly into the expansion<br />
slot. Move the adapter directly from the static-protective package to the<br />
expansion slot.<br />
Attention: Make sure that the adapter is correctly seated in the expansion<br />
slot before you turn on the server. Incomplete installation of an adapter might<br />
damage the system board or the adapter.<br />
10. Install an expansion-slot screw at the rear of the adapter.<br />
11. If you are installing a full-length adapter, press on the release lever on the right<br />
side of the front adapter-retention bracket to release the retaining tab on the<br />
left side of the bracket.<br />
12. Connect required cables to the adapter. Route cables so that they do not block<br />
the flow of air from the fans.<br />
13. Reinstall the rear adapter-retention bracket; then, rotate the bracket to the<br />
closed position.<br />
Note: If any adapters in the server are large or have heavy cables attached to<br />
them, you can remove the rear adapter-retention bracket and secure all of the<br />
adapters with expansion-slot screws.<br />
If you have other devices to install or remove, do so now; otherwise, go to<br />
“Completing the installation” on page 62.<br />
Installing the ServeRAID-BR10il v2 SAS/SATA controller<br />
The IBM ServeRAID-BR10il v2 SAS/SATA controller must be installed in its<br />
dedicated connector, PCI slot 1, on the system board. The ServeRAID-BR10il v2<br />
adapter is supported on hot-swap server models only. The IBM ServeRAID-BR10il<br />
v2 SAS/SATA adapter enables integrated RAID levels 0, 1, and 1E capability on<br />
hot-swap hard disk drives. For configuration information, see the ServeRAID<br />
documentation at http://www.ibm.com/systems/support/.<br />
Attention: Some cluster solutions require specific code levels or coordinated code<br />
updates. If the device is part of a cluster solution, verify that the latest level of code<br />
is supported for the cluster solution before you update the code.<br />
52 System x3200 M3 Types 7327 and 7328: Installation and <strong>User</strong>’s Guide
Change language