User Manual - Etilize
User Manual - Etilize
User Manual - Etilize
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
To install a simple-swap hard disk drive, complete the following steps:<br />
1. Read the safety information that begins on page vii and “Installation guidelines”<br />
on page 29.<br />
2. Turn off the server and peripheral devices and disconnect all external cables<br />
and power cords.<br />
3. Unlock the side cover (the bezel will not disengage from the server if the cover<br />
is locked).<br />
4. Remove the lower bezel (see “Removing the two-piece bezel” on page 32).<br />
5. Touch the static-protective package that contains the drive to any unpainted<br />
metal surface on the server; then, remove the drive from the package and place<br />
it on a static-protective surface.<br />
6. Align the drive assembly with the guide rails in the bay (the connector end of<br />
the drive goes in first).<br />
7. Pull the loops of the drive assembly toward each other; then, carefully slide the<br />
drive assembly into the drive bay until it stops, and release the loops.<br />
Note: Do not release the loops on the drive assembly until it is completely<br />
seated.<br />
If you have other devices to install or remove, do so now; otherwise, go to<br />
“Completing the installation” on page 62.<br />
The simple-swap-drive backplate controls the IDs of the internal simple-swap drive<br />
bays. The following table lists the IDs of the hard disk drives and backplate in<br />
simple-swap models.<br />
Table 13. IDs of simple-swap drives<br />
Drive bay ID<br />
4 0<br />
48 System x3200 M3 Types 7327 and 7328: Installation and <strong>User</strong>’s Guide