User Manual - Etilize
User Manual - Etilize
User Manual - Etilize
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Removing the side cover<br />
Important: Before you install optional hardware, make sure that the server is<br />
working correctly. Start the server, and make sure that the operating system starts,<br />
if an operating system is installed. If the server is not working correctly, see the<br />
Problem Determination and Service Guide for diagnostic information.<br />
To remove the server side cover, complete the following steps.<br />
Attention: Operating the server for more than 30 minutes with the side cover<br />
removed might damage server components. For proper cooling and airflow, replace<br />
the side cover before turning on the server.<br />
1. Read the safety information that begins on page vii and “Installation guidelines”<br />
on page 29.<br />
2. Turn off the server and all attached devices (see “Turning off the server” on<br />
page 22); then, disconnect all power cords and external cables.<br />
3. Unlock the side cover; then, press the cover-release latch down (as shown in<br />
the illustration); then, remove the cover and set it aside.<br />
Cover-release<br />
latch<br />
Key lock<br />
To replace the side cover, see “Reinstalling the side cover” on page 64.<br />
Attention: For proper cooling and airflow, replace the cover before turning on the<br />
server. Operating the server for extended periods of time (more than 30 minutes)<br />
with the cover removed might damage server components.<br />
Removing the two-piece bezel<br />
When you work with some devices, such as drives in bays 1 through 7 (or bays 1<br />
through 11 if you have the 2.5-inch eight-drive model, see page 40), you must first<br />
remove the two-piece bezel to access the devices.<br />
Note:<br />
32 System x3200 M3 Types 7327 and 7328: Installation and <strong>User</strong>’s Guide