08.11.2012 Views

Dell™ PowerEdge™ Expandable RAID Controller 5/i ... - Dell Support

Dell™ PowerEdge™ Expandable RAID Controller 5/i ... - Dell Support

Dell™ PowerEdge™ Expandable RAID Controller 5/i ... - Dell Support

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Figure 3-11. Removing the PERC 5/i Adapter<br />

bracket screw<br />

memory module<br />

NOTE: See the Hardware Owner's Manual for information on removing the PERC 5/i from the system.<br />

Removing the DIMM from a PERC 5/i Card<br />

PERC 5/i Adapter<br />

This section describes how to remove the memory module on a PERC 5/i Adapter or PERC 5/i that is<br />

currently installed in a system.<br />

NOTE: PERC 5 cards support DELL-qualified 256-MB DDRII 400MHz ECC-registered DIMMs with x16 DRAM<br />

components. Installing unsupported memory causes the system to hang at POST.<br />

1 Perform a controlled shutdown on the system in which the PERC 5/i is installed and remove the<br />

PERC 5/i from the system by following the instructions detailed in the section "Removing the<br />

PERC 5/i Adapter" on page 35.<br />

CAUTION: Running a system without the system cover installed can cause damage due to improper cooling.<br />

2 Remove the DIMM by pressing down on the tabs at each edge of the DIMM connector and lifting the<br />

DIMM off the controller.<br />

NOTE: The location of the PERC 5/i varies from system to system. See the Hardware Owner’s Manual<br />

that shipped with the system for specific information on the location of the PERC 5/i.<br />

Hardware Installation and Configuration 37

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!