Download Operating Manual - NY Tech Supply
Download Operating Manual - NY Tech Supply
Download Operating Manual - NY Tech Supply
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Overview<br />
EVACUATION<br />
1. Both manifold valves and both tank valves should still be open.<br />
2. Press SHIFT/RESET until the message "PROGRAM VACUUM MINUTES"<br />
appears on the display.<br />
3. Press VACUUM - The display counts down the vacuum time. Recycling<br />
begins automatically while the system is evacuated.<br />
4. The unit displays CPL when evacuation is complete.<br />
5. Add oil to the A/C system using the oil injector.<br />
6. Press SHIFT/RESET to move to the recharging function.<br />
RECHARGING<br />
Follow the manufacturer’s recommendation for charging.<br />
1. Be sure the appropriate manifold valves are open.<br />
2. Be sure both tank valves are open.<br />
3. Enter the refrigerant charge by weight in hundredths of a pound/kilogram.<br />
4. Press ENTER.<br />
5. Press CHG.<br />
6. The display counts down to 0, then shows CPL when complete.<br />
7. Close both manifold valves and start the vehicle. Set the vehicle’s A/C system<br />
for maximum cooling. Check the gauges and the temperature in the vehicle.<br />
8. Turn off the engine.<br />
9. Disconnect the high side hose (close the 34700/34701/34704 coupler valves<br />
first) and start the vehicle. Open both manifold valves to pull refrigerant from<br />
the hoses.<br />
10. At the lowest recommended operating pressure, close the low side valve and<br />
turn off the vehicle. On the 34700/34701/34704, close the low side valve and<br />
disconnect the low side hose. On the 17700A/17701A, disconnect the low<br />
side hose and remove the adapters.<br />
11. Close both manifold valves and turn off the MAIN POWER switch.<br />
Series 17700A/17701A/34700/34701/34704 Enviro-Charge Units<br />
15