Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

3–Fabric Manager Configuration
Configuring the QLogic Fabric Manager
The following example, will start the Sm, Fe and Bm for the first FM Instance, but
it will not start the Pm. The second FM Instance will be started with an Sm, Fe,
and Pm but no Bm.
1
1
1
0
1
0
1
1
Typically, individual managers will be controlled in the Common section and Fm
Instance startup will be controlled in the Fm.Shared section. In most
configurations, only a single FM Instance will be run with all managers started, in
which case the default qlogic_fm.xml file can be used as provided.
NOTE:
The SM and the PM are unified. As such in order to enable the PM to Start,
its corresponding SM must be enabled. However it is valid to enable the SM
to start without enabling the PM.
IB0054608-01 B 3-13