Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

3–Fabric Manager Configuration
Configuring the QLogic Fabric Manager
Table 3-2. Shared Parameters (Continued)
Parameter
Default
Value
Description
ConfigConsistency-
CheckLevel
ConfigConsistency-
CheckMethod
2 Controls the Configuration Consistency
Check for SM, PM, and BM. Checking can
be completely disabled, or can be set to take
action by deactivating Standby SM, PM, or
BM if configuration does not - pass the consistency
check criteria.
0 = disable Configuration Consistency
Checking
1 = enable Configuration Consistency
Checking without taking action (only log a
message)
2= enable Configuration Consistency
Checking and take action (log message and
move standby to inactive state)
0 Controls the checksum generation method
for Configuration Consistency Checking
between redundant FMs.
MD5 cannot be used when a Host FM and
Embedded FM are being used as a redundant
pair. In which case the simple additive
checksum must be used. The simple additive
checksum method may fail to detect
some configuration differences.
0 = use MD5 checksum method
1 = use simple additive checksum method
DefaultPKey 0xffff The PKey for PM, BM and FE. This should
be the Default PKey so they can manage all
nodes.
Debug
RmppDebug
0 Additional parameters for debug/development
use - These enable debugging modes
for SM, PM, BM and FE. RmppDebug can
be overridden by other RmppDebug in individual
components.
IB0054608-01 B 3-9