Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

3–Fabric Manager Configuration
Configuring the QLogic Fabric Manager
Table 3-2. Shared Parameters (Continued)
LogFile
Parameter
Default
Value
Description
Sets log output location for SM, PM, BM and
FE. By default (or if this parameter is empty)
log output is accomplished using syslog.
However, if a LogFile is specified, logging
will be done to the given file. LogMode
further controls logging.
This parameter is ignored for the QLogic
Embedded Fabric Manager. Consult the
QLogic 12000 Chassis User’s Guide for
information on configuring chassis logging
options.
LogMode 0 Controls mode for logging by SM, PM, BM
and FE.
low two bits control logging as follows:
Low Bit (0/1):
0 - use normal logging levels
1 - logging is quieted by downgrading the
majority of fatal, error, warn and infiniinfo log
messages to level 3 (INFO) and only outputting
user actionable events when LogLevel
is 1 or 2
Next Bit (0/2) (only affects logging when
LogFile specified):
0 - user actionable events go to syslog and
LogFile
2 - when LogFile specified, nothing goes to
syslog
This parameter is ignored for the Embedded
Fabric Manager. Consult the QLogic 12000
Chassis User’s Guide for information on
configuring chassis logging options.
SyslogFacility local6 For the Host FM, controls what syslog facility
code is used for log messages,
Allowed values are: auth, authpriv, cron,
daemon, ftp, kern, local0-local7, lpr, mail,
news, syslog, user, or uucp.
For the Embedded FM, this parameter is
ignored
3-8 IB0054608-01 B