Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

B–QLogic Fabric Manager Log Messages
Other Log Messages
Group Rate/MTU of 5 greater than requester port mtu of 2/4 for group
0xFF12401BFFFF0000:00000000FFFFFFFF for request from Hca1, Port
0x00066a00d9000143, LID 0x0001, returning status 0x0200
SM Area: Administrator.
Meaning: SM may have been set to create the default broadcast group with
parameters not valid for fabric.
Action: Reconfigure the default broadcast group with the proper
parameters.
Group Rate/MTU of X is too low/high for requested rate/mtu of Y, rate/mtu selector of 2,
and port rate/mtu of Z for group 0xFF12401BFFFF0000:00000000FFFFFFFF
in request from Hca1
SM Area: Administrator.
Meaning: The SM may have been set to create a default broadcast group
with parameters not valid for a fabric or a host has created the
group at a RATE not supported by other hosts.
Action: Create the group at lowest common denominator or the host
should join with rate selector of “less than” rather “exactly”.
Subscription for security trap not from trusted source[lid=0x0001], smkey=0x0, returning
status 0x0200
SM Area: Administrator.
Meaning: Requester using wrong smkey.
Action: Make sure to use the same SMkey as what is configured in the SM.
sm_process_vf_info: Virtual Fabric VF0001 has application SA selected, bad PKey
configured 0x1, must use Default PKey.",
SM Area: Administrator.
Meaning: The SA select is limited to Virtual Fabrics using the Default PKey
0x7fff.
Action: Configuration change needed for SA Select.
sm_process_vf_info: Virtual Fabric VF0013 MulticastGroup configuration error, MGID
does not match app, disabling Default Group
SM Area: Administrator.
Meaning: The Multicast Group has an MGID configured that does not match
any application that is part of this Virtual Fabric.
Action: Configuration change needed for mcast group creation.
B-30 IB0054608-01 B