Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

B–QLogic Fabric Manager Log Messages
Other Log Messages
port on other side of node sw1 index x port X is not active
SM Area: Discovery.
Meaning: The node may have been marked down if it did not respond to
SMA queries.
Action: Check the health of the node connected to switch 1 port X.
Node Hca1, port [1], NodeGuid 0x00066a00d9000143 is running at 1X width
SM Area: Discovery.
Meaning: Usually a bad cable. In rare instances, may be a bad port on a
switch or Host Channel Adapter.
Action: Replace the cable. If it is a physical port issue, replacement of the
Host Channel Adapter or switch module is required.
Node Hca1 [0x00066a00d9000143] port[x] returned MKEY[0x1] when MKEY[0x0] was
requested!
SM Area: Discovery.
Meaning: Another SM with a different Mkey configured.
Action: Stop one of the subnet managers and make the configuration
consistent.
Failed to get/set SLVL Map for node Hca1 nodeGuid 0x00066a00d9000143 output port X
SM Area: Discovery.
Meaning: May be caused by simultaneous removal/insertion events in the
fabric. Persistence indicates that the node may be having
problems.
Action: Check the health of the node HCA1/SW1 if the fabric was idle or
persistent condition.
Failed to get/set SLVL Map for switch node sw1 nodeGuid 0x00066a00d9000143 output
port X
SM Area: Discovery.
Meaning: May be caused by simultaneous removal/insertion events in the
fabric. Persistence indicates that the node may be having
problems.
Action: Check the health of node HCA1/SW1 if the fabric was idle or
persistent condition.
B-18 IB0054608-01 B