Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

B–QLogic Fabric Manager Log Messages
Other Log Messages
SM at shaggy HCA-1, portGuid=0x0011750000ff8f4d has a different SM configuration
consistency checksum [418863] from us [417845]
SM Area: SM to SM Communication.
Meaning: The SM on node HCA1 configuration does not match master.
Action: Verify that the XML configuration between master and standby SM
is consistent.
No transitions allowed from DISCOVERING state; Got (ANY) request from [state] SM node
Hca1, LID [0x1], guid [0x00066a00d9000143]
SM Area: SM to SM Communication.
Meaning: The SM on node HCA1 is violating the InfiniBand spec protocol.
Action: If the condition persist, turn off the SM on node HCA1.
SmInfo from SM at SMLID[0x1] indicates SM is no longer master, switching to DISCOVERY
state
SM Area: SM to SM Communication.
Meaning: Remote SM may have handed over to another SM on the fabric.
Action: None.
Switching to DISCOVERY state; Failed to get SmInfo from master SM at LID 0x1
SM Area: SM to SM Communication.
Meaning: Lost the communication path to the other SM at lid 0x1.
Action: Check the health of the node described in the message and the
status of the SM node.
too many errors during sweep, will re-sweep in a few seconds
SM Area: Discovery.
Meaning: Multiple cable pulls or chassis removal/insertion event.
Action: Check links with high error count and reseat or replace cable, If the
condition persist, capture the log information and call support.
unable to setup port [x] of node Sw1/Hca1, nodeGuid 0x00066a00d9000143, marking port
down!
SM Area: Discovery.
Meaning: Lost communication path to node HCA1.
Action: Check the health of the node port described in the message.
B-16 IB0054608-01 B