Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

A–Fabric Manager Command Line Interface
pmLogMode
No longer supported, use “smLogMode logmode” on page A-9.
pmLogMask
No longer supported, use “smLogMask subsystem mask” on page A-9.
pmShowCounters
Get statistics and performance counters about the PM.
pmResetCounters
Reset statistics and performance counters about the PM.
pmDebug
Toggle debug output for PM.
pmRmppDebug
Toggle Rmpp debug output for PM.
feLogLevel loglevel
Set the FE logging level (1=WARN+, 2=INFINI_INFO+, 3=INFO+, 4=VERBOSE+,
5=DEBUG2+, 6=DEBUG3+, 7=TRACE+).
feLogMode logmode
Set the FE log mode flags (0/1 1=downgrade non-actionable, 0/2 2=logfile only).
feLogMask subsystem mask
Set the FE log mask for a specific subsystem to the value given see “Shared
Parameters” on page 3-6 for a list of subsystems and mask bit meanings.
feDebug
Toggle debug output for FE.
feRmppDebug
Toggle Rmpp debug output for FE.
smLooptestStart
START loop test in normal mode - specify the number of 256 byte packets
(default=0).
smLooptestFastModeStart
START loop test in fast mode - specify the number of 256 byte packets
(default=4).
A-10 IB0054608-01 B