Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

A–Fabric Manager Command Line Interface
config_check
Verifies the syntax of a QLogic Fabric Manager XML configuration file.
Syntax
Path:
Keywords
config_check [-c config_file] [-d] [-v] [-s]
/opt/qlogic_fm/etc/
-c config_file
Configuration file to check. Default is /etc/sysconf/qlogic_fm.xml.
-d
Display configuration consistency checksum information for all FM instances. The
checksum calculation method configured within the XML configuration being
tested will be used.
-v
Enable verbose output to display debugging and status information.
-s
Strict check mode. This provides warnings for inconsistencies in the configuration
file such as missing tags or references to undefined names. Such warnings will
not be fatal during normal FM operation, but may represent mistakes in the
supplied configuration file.
Notes
The exit code of this command will indicate the success (0) or failure (non-zero) of
syntax check. On success the command is silent by default. On failure the
configuration syntax errors and warnings will be shown.
Unless -s is specified, checks are limited to syntax.
Warnings will not affect the exit code.
When using an embedded FM, this command is also available on hosts with Fast
Fabric installed in the /opt/iba/fm_tools directory.
A-2 IB0054608-01 B