Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

6–Installation and Set Up
Installing the Host-based Fabric Manager on Linux
Examples: To start the SM for instance 0:
/etc/init.d/qlogic_fm start -i 0 sm
To start the SM for instances 0 and 1:
/etc/init.d/qlogic_fm start -i fm0 -i fm1 sm
To start the SM for all instances:
/etc/init.d/qlogic_fm start sm
To start all managers for instances 0 and 1:
/etc/init.d/qlogic_fm start -i 0 -i 1
To start the SM only for instance 1:
/etc/init.d/qlogic_fm start fm1_sm
NOTE:
Start, restart, and sweep only act on instances and managers enabled
in the configuration file using their corresponding Start parameters.
Removing the Fabric Manager
Refer to the QLogic Fabric Software Installation Guide for removal procedures for
the Fabric Manager.
Stopping the Fabric Manager
To stop the Fabric Manager, follow these steps:
1. Log in to the Fabric Manager system as root or as a user with root
privileges.
2. Stop the Fabric Manager.
/etc/init.d/qloogic_fm stop
The qlogic_fm script shows this message:
st99:/etc/sysconfig # /etc/init.d/qlogic_fm stop
Stopping QLogic Fabric Manager
Stopping FE 0: fm0_fe: [ OK ]
Stopping BM 0: fm0_bm: [ OK ]
Stopping PM 0: fm0_pm: [ OK ]
Stopping SM 0: fm0_sm: [ OK ]
6-4 IB0054608-01 B