Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

More documents

Recommendations

Info

5–Embedded Fabric Manager Commands and Configuration Subnet Management Group CLI Commands smLooptestShowConfig Displays the SM Loop Test Configuration Syntax Keywords Notes Examples smLooptestShowConfig N/A Use this command to print the loop test con figuration for the subnet manager loop test. > smLooptestShowConfig Loop Test is running with following parameters: Max Path Length #Packets Inject Point --------------- -------- ------------ 3 00005 Node 0 FastMode=0, FastMode MinISLRedundancy=4, InjectEachSweep=1, TotalPktsInjected since start=0 5-78 IB0054608-01 B
6 Installation and Set Up Installing the Host-based Fabric Manager on Linux NOTE: The Host QLogic Fabric Manager software requires that the same version of the QLogic InfiniBand Adapter host stack be installed with at least the adapter drivers. These drivers must be set to startup. Installing the Fabric Manager The installation provides an interactive INSTALL and is packaged as a tgz. QLogic recommends to use the ./INSTALL.The rpms are still within the tgz file and can be installed using standard rpm commands if required. The INSTALL command installs the QLogic Fabric Manager (qlogic_fm). When using the INSTALL command (in QLogic-FM-* or QLogicIB-IFS-*), the installation process interactively prompts the user to keep or upgrade the QLogic Fabric Manager configuration file. The new configuration file is always placed in a -sample file for later reference. This procedure is different from the previous rpm install method, where the user had to manually copy the new .rpm file. The installation upgrades any existing /etc/sysconfig/iview_fm.config file to the corresponding /etc/sysconfig/qlogic_fm.xml file. The installer detects if the iview_fm.config file matches the default 4.3.1, 4.3 or 4.2.1.2.1 GA versions, in which case it uses the default qlogic_fm.xml file. If the iview_fm.config file has been edited by the user and does not match one of these prior release files, a converter creates a functionally equivalent qlogic_fm.xml file. If there is no existing iview_fm.config (such as a first time install), a default qlogic_fm.xml is installed. NOTE: For QLogicIB-IFS installations, refer to the QLogic Fabric Software Installation Guide for installation procedures. IB0054608-01 B 6-1
Page 1 and 2:
User Guide Fabric Manager 7.0.1 IB0
Page 3 and 4:
Table of Contents Preface Intended
Page 5 and 6:
Fabric Manager 7.0.1 User Guide Fab
Page 7 and 8:
Fabric Manager 7.0.1 User Guide 4 V
Page 9 and 10:
Fabric Manager 7.0.1 User Guide D E
Page 11 and 12:
Preface Intended Audience This manu
Page 13 and 14:
For details about available service
Page 15 and 16:
1 Overview of the QLogic Fabric Man
Page 17 and 18:
1-Overview of the QLogic Fabric Man
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
2 Advanced Fabric Manager Capabilit
Page 31 and 32:
2-Advanced Fabric Manager Capabilit
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
3 Fabric Manager Configuration This
Page 73 and 74:
3-Fabric Manager Configuration Conf
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
4 Virtual Fabrics Overview Virtual
Page 147 and 148:
4-Virtual Fabrics Configuration Eac
Page 149 and 150:
4-Virtual Fabrics Configuration Tab
Page 151 and 152:
4-Virtual Fabrics Configuration The
Page 153 and 154:
4-Virtual Fabrics Configuration 0
Page 155 and 156:
4-Virtual Fabrics Configuration All
Page 157 and 158:
4-Virtual Fabrics Configuration . T
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
4-Virtual Fabrics Configuration Sec
Page 167 and 168:
4-Virtual Fabrics Configuration Tab
Page 169 and 170:
Page 171 and 172:
4-Virtual Fabrics Configuration
Page 173 and 174:
4-Virtual Fabrics Configuration Al
Page 175 and 176:
5 Embedded Fabric Manager Commands
Page 177 and 178:
5-Embedded Fabric Manager Commands
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202: 5-Embedded Fabric Manager Commands
Page 251: 5-Embedded Fabric Manager Commands
Page 255 and 256: 6-Installation and Set Up Installin
Page 257 and 258: 6-Installation and Set Up Installin
Page 259 and 260: A Fabric Manager Command Line Inter
Page 261 and 262: A-Fabric Manager Command Line Inter
Page 275 and 276: B QLogic Fabric Manager Log Message
Page 277 and 278: B-QLogic Fabric Manager Log Message
Page 303 and 304:
B-QLogic Fabric Manager Log Message
Page 305 and 306:
B-QLogic Fabric Manager Log Message
Page 307 and 308:
C Mapping Old Parameters Versions o
Page 309 and 310:
C-Mapping Old Parameters Old SM Par
Page 311 and 312:
C-Mapping Old Parameters Old SM Par
Page 313 and 314:
C-Mapping Old Parameters Old PM Par
Page 315 and 316:
C-Mapping Old Parameters Old BM Par
Page 317 and 318:
D QOS Options in a Mesh/Torus vFabr
Page 319 and 320:
E ./INSTALL Syntax Syntax ./INSTALL
Page 322:
Corporate Headquarters QLogic Corpo
show all

Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

Create successful ePaper yourself

Delete template?

Save as template?