Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

5–Embedded Fabric Manager Commands and Configuration
Subnet Management Group CLI Commands
smLooptestStart
Starts the SM Loop Test in normal mode. Either accepts a single argument of
“number of packets” or no arguments which will default to 0 packets. Command
will start SM if it is not running.
Syntax
Keywords
smLooptestStart [packets]
packets
The number of 256 byte packets used when starting the SM Loop Test. Valid
values are 0-10.
Notes Use this command to start the SM Loop Test with the specified number of 256
byte packets. Valid values for number of packets are 0-10 (default=0). If the
number of packets is 0, then no packets will be injected. If SM has not been
previously started this command will start SM. Note that Loop Test will only
function if the SM is in the Master state.
Examples > smLooptestStart 5
Waiting for SM to complete startup.......................done
The SM Loop Test is being started
5-66 IB0054608-01 B