Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

5–Embedded Fabric Manager Commands and Configuration
Subnet Management Group CLI Commands
Fabric Manager Loop Test
The following commands set up and perform loop test in the fabric.The Loop Test
should be performed after an installation or major changes have occurred in the
fabric or cluster to help validate that data is being transported as intended.
• smLooptestStart – Starts the SM Loop Test in normal mode
• smLooptestFastModeStart – Starts the SM Loop Test in fast mode
• smLooptestStop – Stops the SM Loop Test
• smLooptestInjectPackets – Injects packets into the SM Loop Test
• smLooptestInjectAtNode – Injects packets to a specific switch node for the
SM Loop Test
• smLooptestInjectEachSweep – Injects packets on each sweep for the SM
Loop Test
• smLooptestPathLength – Sets the loop path length for the SM Loop Test
• smLooptestMinISLRedundancy – Sets the minimum ISL redundancy in fast
mode for the SM Loop Test
• smLooptestShowLoopPaths – Displays the loop paths for the SM Loop Test
• smLooptestShowSwitchLft – Displays a switch's LFT for the SM Loop Test
• smLooptestShowTopology – Displays the topology for the SM Loop Test
• smLooptestShowConfig – Displays the con figuration for the SM Loop Test
IB0054608-01 B 5-65