Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

5–Embedded Fabric Manager Commands and Configuration
Subnet Management Group CLI Commands
smConfig
Authority
Syntax
Keywords
Configure startup parameters of the embedded subnet manager.
smConfig [query] [startAtBoot yes|no] [startOnSlaveCmu yes|no]
query
Display present settings, no change.
startAtBoot yes | no
yes – Start the subnet manager at chassis boot.
no – Do not start the subnet manager at chassis boot.
startOnSlaveCmu yes | no
yes – Start the subnet manager on the slave CMU.
no – Do not start the subnet manager on the slave CMU.
Notes
Examples
Use this command to configure the subnet manager. Changes to these
parameters will not take effect until the next reboot of the Chassis Management
Card(s).
This command can only be run on the master Chassis Management Card.
-> smconfig query
startAtBoot: no
startOnSlaveCmu: no
->
-or-
-> smConfig
Start at boot [Y]
Start on slave CMU [N]
->
-or-
-> smconfig startAtBoot yes startOnSlaveCmu yes
Saving....
Saving complete...
5-4 IB0054608-01 B