Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

5–Embedded Fabric Manager Commands and Configuration
Subnet Management Group CLI Commands
Determining the Active Fabric Manager
In a configuration with multiple QLogic or SilverStorm switches, use the following
CLI command to determine the active Fabric Manager:
smShowMasterLid
To determine if this FM is the master, use the following CLI command:
smControl status
Similar information can also be obtained using the FastFabric CLI commands:
fabric_info, iba_top, iba_saquery or iba_report.
Subnet Management Group CLI Commands
The following pages define the group CLI commands and give the syntax, options
and a sample output of each. With the exception of the smConfig,
smPmBmStart, smShowConfig and smResetConfig commands, these
commands only act against the Management Card presently logged into. In order
to act on the FM running on the slave management card, it is necessary to login
into that card.
Operational Controls
The following commands control the configuration and operation of the Fabric
Manager.
5-2 IB0054608-01 B