Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

3–Fabric Manager Configuration
Configuring the QLogic Fabric Manager
Table 3-29. Additional Pm Parameters (Continued)
Parameter
Default
Value
Description
ConfigConsistencyCheck-
Level
ConfigConsistencyCheck-
Method
2 Controls the Configuration Consistency
Check for PM. If specified for an individual
instance of PM, will override Shared
settings. Checking can be completely disabled,
or can be set to take action by
deactivating Secondary PM if configuration
does not pass the consistency check
criteria.
• 0 = disable Configuration Consistency
Checking
• 1 = enable Configuration Consistency
Checking without taking action (only
log a message)
• 2= enable Configuration Consistency
Checking and take action (log message
and shutdown Secondary PM)
0 Controls the checksum generation
method for Configuration Consistency
Checking between redundant PMs. Will
override Common.Shared settings if
specified per instance. Checking MD5
cannot be used when a Host Fabric Manager
and Embedded Fabric Manager are
being used as a redundant pair. In which
case the simple additive checksum must
be used. The simple additive checksum
mechanism may fail to detect some configuration
differences.
• 0 = use MD5 checksum method
• 1 = use simple additive checksum
method
Priority 0 0 to 15, higher wins.
ElevatedPriority
0 to 15, higher wins.
DefaultPKey 0xffff Overrides setting from Common.Shared
for PM
The PKey for PM. This should be the
Default PKey so they can manage all
nodes.
3-66 IB0054608-01 B