Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

3–Fabric Manager Configuration
Configuring the QLogic Fabric Manager
Table 3-21. Additional Fe Parameters (Continued)
Parameter
Default
Value
Description
SyslogFacility Local6 Note: overrides Common.Shared setting.
For the Host FM, controls what syslog
facility code is used for log messages,
Allowed values are: auth, authpriv, cron,
daemon, ftp, kern, local0-local7, lpr, mail,
news, syslog, user, or uucp.
For the Embedded FM, this parameter is
ignored
ConfigConsistencyCheck-
Method
0 Only the ConfigConsistencyCheck-
Method can be changed for Fe.
DefaultPKey 0xffff Overrides setting from Common.Shared
for FE. The PKey for FE. This should be
the Default PKey so they can manage all
nodes.
Additional Parameters for Debug and Development
The Fe supports the parameters in Table 3-22 to aid diagnosis and debug. Only
use these parameters under the direction of your support representative.
Table 3-22. Fe Debug Parameters
Parameter
Default
Value
Description
Debug 0 Note: Overrides Debug setting from
Common.Shared
Additional parameters for debug/development
use - This enables debugging
modes for FE.
RmppDebug 0 Note: Overrides RmppDebug setting
from Common.Shared
If 1, then log additional FE info with
regards to RMPP or the Reliable Message
Passing Protocol.
3-54 IB0054608-01 B