Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

3–Fabric Manager Configuration
Configuring the QLogic Fabric Manager
Table 3-19. Additional Sm Parameters (Continued)
Parameter
Default
Value
Description
ConfigConsistencyCheck-
Level
ConfigConsistencyCheck-
Method
2 Controls the Configuration Consistency
Check for SM. If specified for an individual
instance of SM, will override Shared
settings. Checking can be completely disabled,
or can be set to take action by
deactivating Standby SM if configuration
does not pass the consistency check criteria.
• 0 = disable Configuration Consistency
Checking
• 1 = enable Configuration Consistency
Checking without taking action (only
log a message)
• 2= enable Configuration Consistency
Checking and take action (log message
and move standby to inactive
state)
0 Controls the checksum generation
method for Configuration Consistency
Checking between redundant FMs. Will
override Shared settings if specified per
instance. Checking MD5 cannot be used
when a Host FM and Embedded FM are
being used as a redundant pair. In which
case the simple additive checksum must
be used. The simple additive checksum
mechanism may fail to detect some configuration
differences.
• 0 = use MD5 checksum method
• 1 = use simple additive checksum
method
Additional Parameters for Debug and Development
The SM supports the parameters in Table 3-20 to aid diagnosis and debug. Only
use these parameters under the direction of your support representative.
3-50 IB0054608-01 B