Fabric Manager Users Guide, Version 6.1, Revision A - QLogic

3–Fabric Manager Configuration
Configuring the QLogic Fabric Manager
Table 3-16. Sm Fabric Sweep Parameters (Continued)
Parameter
NonRespTimeout
NonRespMaxCount
Default
Value
600
3
Description
When a node is under heavy load, it may fail to
respond to SMA queries for a while. In order to
prevent the SM from dropping such nodes from
the fabric, the SM will allow a node to be non
responsive for up to NonRespMaxCount sweeps
and NonRespTimeout seconds before dropping
it from the fabric.
SM Logging and Debug
When nodes appear or disappear from the fabric, a message is logged. The SM
Logging/Debug section defines how many messages are logged, and if additional
SM sweep and SA query debug information is logged. The following is a sample
of the SM Logging/Debug section of the FM configuration file.
100
0
0
The parameters in Table 3-17 control SM Logging.
Table 3-17. Sm Logging and Debug Parameters
Parameter
Default
Value
Description
NodeAppearanceMsgThreshold
100 This can set a threshold on how many log
messages to output per sweep. Once
NodeAppearanceMsgThreshold
messages are logged in a given sweep,
the remainder are output at a lower log
level (INFO) therefore avoiding excessive
log messages when significant fabric
changes occur.
0 means no limit.
IB0054608-01 B 3-47