checklist - ERAU ETA - Embry-Riddle Aeronautical University
checklist - ERAU ETA - Embry-Riddle Aeronautical University
checklist - ERAU ETA - Embry-Riddle Aeronautical University
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
PA-28R-201 SOP 87<br />
AFTER LANDING CHECKLIST<br />
Accomplish only when clear of the runway and stopped<br />
completely.<br />
1. STABILATOR TRIM ............................................................. N (Neutral)<br />
2. FLAPS .............................................................................. RETRACT 0°<br />
3. MIXTURE ..................................................................................... LEAN<br />
4. ELECTRIC FUEL PUMP ................................................................ OFF<br />
5. LIGHTS (except Fin Strobe) ........................................................... OFF<br />
6. PITOT HEAT .................................................................................. OFF<br />
7. TRANSPONDER .......................................................................... STBY<br />
8. AFTER LANDING CHECKLIST .......................................... COMPLETE<br />
1. STABILATOR TRIM/RUDDER TRIM N (Neutral)<br />
Set the STABILATOR TRIM to the N (Neutral) position.<br />
2. FLAPS RETRACT 0°<br />
Before changing the flap position on the ground, verify that you have the<br />
Flap Control Handle and call out, “Flaps Identified”. Wait for the IP to<br />
respond, “Flaps Verified”, then RETRACT the FLAPS the the 0° position.<br />
Visually verify that the flaps move towards and stop in the fully retracted<br />
position and call out, “Flaps Up.” Wait for the IP to respond, “Flaps Up,<br />
Verified.”<br />
3. MIXTURE LEAN<br />
Move the control for the MIXTURE aft slowly to the stop to LEAN.<br />
4. ELECTRIC FUEL PUMP OFF<br />
Depress the ELECTRIC FUEL PUMP switch to the OFF position. Check<br />
fuel pressures. A slight decrease in fuel pressure may be observed.<br />
5. LIGHTS (except Fin Strobe) OFF<br />
Adjust the LIGHTS (except the Fin Strobe) as appropriate:<br />
- Day: Turn the landing light and strobe lights OFF.<br />
- Night: Turn the strobe lights OFF. Use the landing light as<br />
necessary for taxi. Nav lights should be ON per 14 CFR Part 91.209.<br />
Rev 06 © <strong>Embry</strong>-<strong>Riddle</strong> <strong>Aeronautical</strong> <strong>University</strong> Revised 07-01-2012