checklist - ERAU ETA - Embry-Riddle Aeronautical University
checklist - ERAU ETA - Embry-Riddle Aeronautical University
checklist - ERAU ETA - Embry-Riddle Aeronautical University
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
120 PA-28R-201 SOP<br />
5. HEATER/DEFROSTER OFF<br />
Move the HEATER and DEFROSTER levers to the OFF position.<br />
If the fire persists:<br />
6. AIRSPEED INCREASE<br />
INCREASE the AIRSPEED in an attempt to extinguish the fire.<br />
Emergency Landing Without Engine Power Checklist:<br />
7. PASSENGER SEATS/SEATBACKS UPRIGHT<br />
Ensure that all PASSENGER SEATBACKS are in the full UPRIGHT<br />
position for landing.<br />
8. SEATBELTS/HARNESSES ON<br />
Ensure that passenger SEATBELTS and shoulder HARNESSES are ON<br />
and adjusted.<br />
9. GEAR SELECTOR DOWN/ 3 GREEN<br />
Verify that the GEAR SELECTOR is in the DOWN position. Visually check<br />
to confirm that the 3 GREEN indicator lights are illuminated. Call out,<br />
“Three Green, No Red, Verify.” Wait for the IP to respond, “Gear Down,<br />
Verified.”<br />
10. FLAPS 40° Recommended<br />
When appropriate, place the Flap Selector switch in the 40º position to set<br />
the FLAPS for approach and landing, allowing touchdown at the slowest<br />
possible airspeed.<br />
11. MIXTURE CONTROL IDLE CUT-OFF<br />
Place the MIXTURE CONTROL to the IDLE CUT-OFF position.<br />
12. THROTTLE CLOSE<br />
Move the THROTTLE to the CLOSE position.<br />
13. FUEL SELECTOR OFF<br />
Place the FUEL SELECTOR in the OFF position.<br />
14. IGNITION SWITCH OFF<br />
Turn the IGNITION SWITCH key to the OFF position.<br />
Revised 07-01-2012 © <strong>Embry</strong>-<strong>Riddle</strong> <strong>Aeronautical</strong> <strong>University</strong> Rev 06