checklist - ERAU ETA - Embry-Riddle Aeronautical University

PA-28R-201 SOP 109
19. GEAR SELECTOR DOWN/ 3 GREEN
Verify that the GEAR SELECTOR is in the DOWN position. Visually check
to confirm that the 3 GREEN indicator lights are illuminated. Call out,
“Three Green, No Red, Verify.” Wait for the IP to respond, “Gear Down,
Verified.”
20. FLAPS 40° Recommended
When appropriate, place the Flap Selector switch in the 40º position to set
the FLAPS for approach and landing, allowing touchdown at the slowest
possible airspeed.
21. MIXTURE CONTROL IDLE CUT-OFF
Place the MIXTURE CONTROL to the IDLE CUT-OFF position.
22. THROTTLE CLOSE
Move the THROTTLE to the CLOSE position.
23. FUEL SELECTOR OFF
Place the FUEL SELECTOR in the OFF position.
24. IGNITION SWITCH OFF
Turn the IGNITION SWITCH key to the OFF position.
25. BATTERY MASTER SWITCH LANDING ASSURED/OFF
When the LANDING is ASSURED, depress the BATTERY MASTER
SWITCH to the OFF position.
26. CABIN DOOR UNLATCH
Lift the interior door handles to UNLATCH and open the CABIN DOOR to
prevent the possibility of having the cabin doors jammed upon landing.
Once opened, place the interior door handles in the locked (full forward,
down) position to prevent the doors from closing and latching.
27. TOUCHDOWN SLIGHTLY TAIL-LOW
Touch down in a SLIGHTLY TAIL-LOW attitude to aid in slowing the
airplane during the landing roll.
28. BRAKES APPLY HEAVILY
APPLY the BRAKES HEAVILY, or as necessary, to stop the airplane prior
to encountering any surrounding obstructions or rough terrain surfaces.
Rev 06 © Embry-Riddle Aeronautical University Revised 07-01-2012