You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
TROUBLESHOOTING<br />
Problem Cause Solution<br />
Motor stalls (resulting in blown<br />
fuses or tripped circuit breakers).<br />
Starting switch not operating.<br />
Voltage too low to permit motor to<br />
reach operating speed.<br />
Fuses or circuit breakers do not<br />
have sufficient capacity<br />
Have switch replaced.<br />
Request voltage check from the power<br />
company.<br />
Install proper size fuses or circuit breakers.<br />
Frequent opening of fuses or circuit<br />
breakers.<br />
Motor overloaded.<br />
Fuses or circuit breakers do not<br />
have sufficient capacity.<br />
Starting switch not operating (motor<br />
does not reach speed)<br />
Feed work slower into blade.<br />
Install proper size fuses or circuit breakers.<br />
Check that wiring will handle load.<br />
Have switch replaced. Blow out sawdust.<br />
Blade does not run in the approximate<br />
center of the upper wheel.<br />
Not tracking properly.<br />
Adjust tracking, see Assembly section,<br />
"Tracking the Blade” section.<br />
Band Saw slows down when<br />
cutting.<br />
Belt too loose.<br />
Cutting too small a radius.<br />
Dull blade.<br />
Overloading motor.<br />
Adjust belt tension, see Assembly<br />
section, “Mounting the Motor Assembly”.<br />
Stop feeding, and back up the material<br />
slightly, until the band saw speeds up.<br />
Replace blade.<br />
Slow down, trying to cut too fast.<br />
Blades breaking<br />
Too much tension on blade.<br />
Adjust tension. See Assembly section,<br />
“Adjusting Blade Tension”.<br />
Kink in blade caused cutting too<br />
small a radius or turning the material<br />
too fast when cutting.<br />
Use correct cutting technique. See<br />
Operation section.<br />
Blade dulls too quickly.<br />
Blade guides set too close to teeth.<br />
Cutting incorrect material.<br />
Adjust upper and lower blades guides.<br />
See Assembly section “Installing and<br />
Adjusting the blade”.<br />
Band saw vibrates.<br />
Too much tension on motor belt.<br />
Adjust according to “Mounting the Motor<br />
Assembly” section.<br />
33