Manual 3060 System - SimonsVoss technologies

Manual – Digital locking cylinder 3061
Page 4
1. General
1.1 Notes on safety
• Lock installation and battery changes should only be carried out by trained
personnel.
• The cylinder must not come into contact with oil, paint or acids.
• Only use batteries approved by SimonsVoss (see chapter 11).
• The batteries used in digital locking cylinder 3061 can cause a fire or burns
if handled incorrectly. Do not charge, open, heat up or burn batteries. Do
not short-circuit.
• Dispose of old or used batteries properly, and keep them out of the reach of
children.
• Reversing polarity can result in damage to the locking cylinder.
• Always replace both batteries at the same time.
• When replacing batteries, do not touch the contact areas on new batteries.
Always use clean, grease-free gloves.
• Cylinder operation requires two batteries.
• Use the .WP version for outdoors installations.
• The locking cylinder's internal knob (electronic side with keypad) complies
with Protection Class IP40. It must therefore be ensured that the knob does
not come into contact with water.
• SimonsVoss Technologies AG shall not be liable for damage to doors or
components resulting from incorrect installation.
• An incorrectly installed or incorrectly programmed cylinder can block access
through a door. SimonsVoss Technologies AG shall not be liable for any
consequences of incorrect installation, such as lack of access to injured
persons, material damage or other damage.
• Alterations and technical developments reserved.
• This documentation was prepared to the best of our knowledge; however
errors cannot be completely ruled out. No liability is accepted in this event.
• The content of the German original shall overrule in case of differences in
the content of foreign-language versions.