01.12.2014 Views

Manual 3060 System - SimonsVoss technologies

Manual 3060 System - SimonsVoss technologies

Manual 3060 System - SimonsVoss technologies

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

SmartCD Programming Device<br />

Page 8<br />

9.0 Replacement of the batteries<br />

Please proceed as follows when you need to change the batteries:<br />

• Remove the belt clip carefully (if you use a small Phillips screwdriver, you do not<br />

need to remove the belt clip).<br />

• Remove the screw on the back of the unit.<br />

• Detach the bottom half of the housing.<br />

• Take out the old batteries and insert the new batteries with the positive pole<br />

pointing upwards as shown in the diagram. Observe correct polarity and make<br />

sure you are using the correct battery type.<br />

• Replace the bottom half of the housing and fasten the screw finger-tight.<br />

• Attach the belt clip.<br />

+ +<br />

Batteries<br />

- -<br />

Antenna<br />

8

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!