Manual 3060 System - SimonsVoss technologies

Programming Transponder 3067
Page 7
4. The Programming Transponder repeats the ID number that you enter as a
check. First the LED briefly lights yellowish. Then the Programming
Transponder outputs the ID number with red and green blinking. The color
then changes back to yellow and finally the LED blinks green.
5. If the displayed number is correct, hold the Programming Transponder near
the inner knob of the cylinder (long knob) and press its button.
6. Then the data transfer takes place (signal tones on the cylinder). Wait until the
LED has lit green for 3 seconds and the cylinder has coupled. The data
transfer is not completed until this happens.
4.0 Loss of the Programming Transponder
Get your backup card and contact your dealer. You will receive a new Programming
Transponder, which you first must reauthorize for your cylinders.
To do this, proceed as follows:
1. Hold your new Programming Transponder in front of a cylinder and press its
button twice. The LED lights green for approximately 3 seconds and the
cylinder couples.
2. Then hold your new Programming Transponder in front of the same cylinder,
but this time press its button only once.
3. The light emitting diode blinks yellowish and goes out. The cylinder couples
and the LED lights green for approximately 3 seconds.
4. Repeat steps 2 and 3 for all other cylinders in your locking system.
5. Once you have authorised the new Programming Transponder on all
cylinders, press its button until the LED stops blinking.
6. The new Programming Transponder is now ready to use.
5.0 Data Sheet
Housing Material Plastic
Colour
Grey
Dimensions
58 x 38 x 12.3 mm