Manual 3060 System - SimonsVoss technologies

Programming Transponder 3067
Page 6
3.5 Emergency Opening
It is possible to perform an emergency opening with the Programming Transponder.
Proceed as follows:
1. Press the Programming Transponder button briefly one time. Then the LED
blinks green.
2. Hold the Programming Transponder at a distance of approximately 10 to
20 cm (approximately 4 to 8 inches) from the locking cylinder and briefly press
the button.
Attention: you must press the button during the LED’s blinking phase.
3.6 Blocking a Lost Transponder
The procedure depends on whether or not you know the ID number of the lost
transponder. If you do not know it, proceed as follows:
1. Press the Programming Transponder button until the light emitting diode
blinks red.
2. Hold the Programming Transponder near the inner knob of the cylinder (long
knob) until the LED lights green for approximately 3 seconds and the cylinder
couples.
3. You have now deleted all authorised transponders and must reprogram then
as described in Chapter 3.2.
If you know the ID number, you can block this specific transponder with the following
steps:
Note: It is important that the steps be executed quickly for this procedure, too.
Memorise the ID number of the transponder so that you can enter it immediately in
the
following steps. Like when reading out the number, the input is done in tens (red) and
ones (green).
1. Press the Programming Transponder button until the light emitting diode
blinks red. Then release the button.
2. Then repeat the procedure and wait until the LED lights red. Immediately (red
LED must still be lit) press the Programming Transponder button the
appropriate number of times to enter the number of tens (only if there are
more than nine transponders).
3. The LED now begins to light green. Now enter the number of ones in the
same way (now the green LED must still be lit).