Manual 3060 System - SimonsVoss technologies

Programming Transponder 3067
Page 5
its
button one time. Attention: you must press the button during the LED’s
blinking phase. The data is then transferred. The locking cylinder makes
several signal tones during this part of the programming. If the programming
was successful, the cylinder couples and the LED on the Programming
Transponder lights green.
4. Perform a test to see whether all of the transponders that you have
programmed function perfectly.
5. Follow the same procedure to program additional locking cylinders.
3.3 Reading Out a Transponder
In order to be able to block a lost transponder for a specific locking cylinder, you need
its ID number. We recommend that you create a list containing the name of the owner
and the accompanying ID number of the transponder. You can determine this with the
Programming Transponder:
1. Briefly operate the Programming Transponder until it blinks green.
2. Hold the transponder whose ID number you want to read out near the
Programming Transponder. Briefly operate the transponder. The LED on the
Programming Transponder lights green for approximately 3 seconds.
3. Press the transponder button again. The LED lights yellowish for
approximately 2 seconds.
4. The ID number of the transponder is shown by the different coloured blinking
of the LED.
Red blinking indicates the tens and green blinking indicates the ones.
Example: If the ID number of the transponder is 25, the LED blinks red 2x and
then green 5x. If the ID number has only one digit, only the green LED blinks.
5. Once the ID number has been determined, the LED on the Programming
Transponder lights yellowish again.
3.4 Adding a New Transponder
If you want to authorise a new transponder, proceed in the same way as for the initial
programming. You do not have to repeat the procedure for reading in transponders
that were already authorised for locking.